Pocket PC Stand
The popular Reyburn CyberTuner, TuneLab, and Veritune
piano tuning softwares are available for "pocket PC"
handheld computers as well as the iPhone 4 and iPod Touch.
You can learn all about these softwares at:
www.reyburn.com, www.tunelab-world.com, and
Once you get your software, you'll need a stand to support
your pocket PC on the piano while tuning. This stand holds
the PC securely, slips easily on or off, and works equally well
on verticals or grands. Four models to fit most pocket PCs
plus the iPod Touch and iPhone 4.
For grands, just slip the tuning tip over a tuning pin, as
shown at right. You can then face it any direction, easily
adjust the tilt for best viewing angle, and rotate the PC to
horizontal when running in full screen mode. Or, swing the
tuning tip back and the stand will sit like a tripod on the
plate or strings.
The same options work equally well on vertical pianos. Swing
the tuning tip back as shown below right and the stand will
sit on the lid, pin block, or other horizontal surface. Most
convenient and secure is to mount the stand on vertical
piano tuning pins, where it can be faced right or left, and
tilted up or down.
Made of high density polyethylene, the stand weights just
under 4 oz. (112 gm). Requires a standard thread tuning tip
(not included. Most techs have an extra, or we can provide
one for an additional $8.00).
Four stand models available:
The Clips type is available in four sizes:
Small: for HP 1700/1900/4000 series, HP 110, 111, 114, HP
rx3115, rx3417, rx1715, rx1950, series
Medium: for HP 2200 series
Large: for Compaq 3600 thru 3900 series, HP h4350, h5150,
h5550, HP hx2100, hx2400, hx2700, hx4700, hx5915, HP 211,
214, all Dell Axim, and Toshiba e755
iPhone 4/iPod Touch: Fits devices that measure 57-59mm
wide and 7-10mm thick
The clips stand holds the bare iPhone, accessory cases may
make it too thick to fit the stand.
Converting your existing stand to a different model: If you
switch to a different size Pocket PC there is no need to buy
a complete new stand. Any stand can be converted to a
different size or type just by replacing the clips or Velcro
mount (just the top part of the stand that actually holds the
PC). Just order the appropriate size "Clips" conversion kit
(see order form).
PC stands are now discontinued, however we do have a few spare parts available.
Call or email to inquire.